Quote Cart(0)
image product add to cart

This product has been added to your cart

Zebra MC9400 Easy Steps For Battery Removal And Replacement

To remove or replace the battery on the Zebra MC9400 mobile computers is fairly easy and can be done within minutes.

Watch the video below.

Step-By-Step Instructions To Remove Or Replace The Battery On the Zebra MC9400

To replace or remove the battery in a Zebra MC9400, follow these general steps:

Materials you’ll need:

– Replacement battery for Zebra MC9400

– Small screwdriver (typically a Torx screwdriver)

– ESD (Electrostatic Discharge) strap (optional but recommended)

Steps:

  1. Power Down the Device: Ensure the Zebra MC9400 is completely powered off before starting the replacement.
  2. Remove the Back Cover:

    – Use the screwdriver to remove the screws securing the back cover of the MC9400. These screws are typically located around the perimeter of the device.

    – Once the screws are removed, gently lift the back cover off.

  3. Locate the Battery:

    – The battery is usually a large, rectangular part within the back of the device.

    – You might see a connector that connects the battery to the device’s internal components.

  4. Disconnect the Old Battery:

    – Carefully disconnect the battery from the device. This may require lifting or sliding out the connector that attaches the battery.

    – If necessary, you can use a plastic tool to avoid damaging any connectors.

  5. Remove the Old Battery:

    – Once the battery is disconnected, remove it from its compartment. Take care not to damage any surrounding components.

  6. Install the New Battery:

    – Place the new battery into the compartment and connect it to the device.

    – Ensure the connector is properly attached to the battery and device.

  7. Reassemble the Device:

    – Once the battery is in place and connected, replace the back cover of the MC9400.

    – Secure the cover by screwing it back in place.

  8. Power On the Device:

    – Turn the MC9400 back on to make sure the new battery is functioning properly.

  9. Calibrate if Necessary:

    – Some devices may require recalibration after a battery replacement, so follow any on-screen instructions to complete the process.

Make sure to follow any specific instructions provided with the replacement battery, as there may be slight differences depending on the model or version of the Zebra MC9400 you have. If you don’t feel comfortable replacing the battery yourself, it’s always a good idea to seek professional help.



Schedule Zebra MC9400 Service

Schedule Zebra MC9400 service with a Zebra certified technician today!

click to call