Zebra ZT600 Peel Off Mode

Watch the video below.

Step-By-Step Instructions For Peel Off Mode On The Zebra ZT600 Series

Loading Media for Peel-Off Mode

1. Open the Printhead Assembly: Lift the printhead-open lever to raise the printhead.​
2. Feed the Media:

   – Slide the media guide all the way out.

   – Feed the media under the dancer assembly, through the media sensor, and under the printhead assembly.

   – Slide the media back until it touches the inside back wall of the media sensor.

3. Extend the Media: Pull approximately 18 inches (500 mm) of media out of the printer.​
4. Remove Labels: Remove and discard the labels from the exposed media, leaving just the liner.
5. Feed the Liner:

   – Feed the liner behind the peel assembly, ensuring the end of the liner falls outside the printer.

   – If using Liner Take-Up, thread the liner into the slot below the peel assembly and under the media alignment roller.​

6. Close the Printhead: Rotate the printhead-open lever downward to lock the printhead in place.
7. Set Peel-Off Mode: On the printer’s control panel, navigate to the settings menu and select “Peel-Off” mode.
8. Close the Media Door: Ensure the media door is securely closed.​
9. Start Printing: Press the PAUSE button to exit pause mode and begin printing.​